Setting up wood router bits in fusions tool library

[daniel_lyall]

The attached file is a rough draft of a tot for setting wood router bits in fusions tool Library.

@Laurens-3DTechDraw 

@sekrit_skworl this is just a start I will do a few other tool types, I don't have a lot of free time at the moment.

I have some other info to add that I have to get permission to use.

[dclark]

I wish they had a tool library autoloader - that worked from a csv file.  I use an add on to store dimensions.  The menus are too much work.  I would like to just pound through a dozen router bits and be done with it. 

the current tool lookup is pretty hard to understand.

thanks for spelling this out.

[daniel_lyall]

@dclark it takes a bit to get use to useing it, a csv to json to csv converter would be good