VDM map stamp issue
Not applicable
10-15-2014
03:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hello all,
I am experienceing a problem in mubox in which when I try to use a vector displacement map I made of a crater as a stamp the mesh get's stamped, but get's pushed to one side. The example below has very low buildup and strength settings. It usually get's pushed out much further. Stencil doesn't work either
I don't think it is the map though, because when I sculpt another plane with the sculpt by map option, it comes out fine:
I do need to use it as a stamp so that I can place the geometry on a much larger mesh that I've already added a lot to.
Any advice is appreciated,
Thanks,
Mitchell
Link copied