Hot Runner

[2021898104]

Hi, May I know how to run the analysis after I set the hot runner due to it told that my analysis was failed?

** ERROR 220120 ** No connection between beam and tetrahedral cavity elements.

 
Or else, how the process of mesh, set the runner, inject location flow?

[bernor_mf]

@2021898104 

Hi,

You need to fix the connectivity issue.
Use connectivity diagnostic to identify where the problem is located.
Click Mesh > Mesh Diagnostic > Connectivity

Good information:

"ERROR 220120: No connection between beam and tetrahedral cavity elements" in Moldflow

Solver message 220120

Hope this helps.

Regards,

Berndt

[vasyabc]

Hi,

Please check connectivity diagnostic if hot runner beams and part tetras are connected. if not connected need to merge nodes.

share image of hot runner and part tetra connectivity diagnostic result image.

Regards,

B.Vasanth