Community
Meshmixer
Welcome to Autodesk’s Meshmixer Forums. Share your knowledge, ask questions, and explore popular Meshmixer topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

when I install a new STL file I only get a previous one.

3 REPLIES 3
Reply
Message 1 of 4
TSmith1916
192 Views, 3 Replies

when I install a new STL file I only get a previous one.

Chimney support 1.jpgChimney support 2.jpg

3 REPLIES 3
Message 2 of 4
hfcandrew
in reply to: TSmith1916

I'm not sure what that means,

 

Also, see the stickied post re: graphics rendering

Message 3 of 4
TSmith1916
in reply to: hfcandrew

Thanks for your reply.The 2 photos show what happens. The Fusion 360 file is completely new, then when I change it to an STL file and put it into Meshmixer it comes up as one that I did some time ago. I have removed the old Meshmixer and replaced it with a new one, re-made a new version of the item in Fusion 360 and then converted it into an STL file which then goes into Meshmixer and that's what it becomes. I've tried all sorts of things to get the right Meshmixer setup to npo avail. RegardsTony
Message 4 of 4
hfcandrew
in reply to: TSmith1916

What makes you think it is the same file? Based on what metrics.

 

I've never heard of this issue with MM, so I dont think its MM. Can you import any other .stl into MM? If so then its probably a Fusion360 export issue, and not MM.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report