Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Add divisions to mesh after using boolean operator

Anonymous

Add divisions to mesh after using boolean operator

Anonymous
Not applicable

Hey, I am trying to subdivide a cliff/rock geometry to sculpt and vertex-paint it. I used a boolean operator to carve a door and a small corridor in it. This is how it looks:

The entranceThe entrance

If I now go to "Edit Mesh -> Add Divisions", it will result in this:

The messThe mess

And it gets even worse if I use polySmooth:

3.png

 

There are even faces that cover a part of the door. I already tried to draw a square 'frame' around the door but it will give me the same result. Why does it not divide properly?

 

Best regards

 

0 Likes
Reply
457 Views
1 Reply
Reply (1)

mspeer
Consultant
Consultant

Hi!

 

Subdivide manual around the door.

0 Likes