Duplicate Special Issue

[megcook]

Hello!

I'm trying to create an object with duplicate special, but it's leaving gaps between the pieces of geometry. I'm not sure what is causing this - I've checked the duplicate special settings, transformations, pivot point, etc. 

I know I can merge the vertices to close the gaps, but I was just curious if anyone knew what was causing this. 

Thanks in advance.

[mspeer · Accepted solution]

Hi!

If the values for Duplicate Special are set correct, then the faces are simply too small.

[megcook]

Hello! Thank you for your response!

The piece of geometry that I posted was a modified piece of this original form:

Could the faces be too small even if they were connected in the original form?

[mspeer]

Hi!

How was this object created?

By looking at the image I can't tell if these faces all have the exact same size.

Please provide a scene-file for further help.

[megcook]

Here's a link to the scene file:

https://we.tl/t-kyxQig9lb7 

[mspeer]

Hi!

I don't know what you did, but my first assumption was correct,

the faces are smaller than on the original object from the Revolve.

[megcook]

I'm not sure how that happened, but that definitely explains the issue. Thank you so much for your help!