Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Unable to rectangular pattern icopy component!

Mohamed_Bakr
Enthusiast

Unable to rectangular pattern icopy component!

Mohamed_Bakr
Enthusiast
Enthusiast

Hi,

I created icopy component which is a curtain wall panel, i placed the icopy into the target assembly and everything was fine, then i started to use the pattern to make a rectangular pattern of the "icopy panel", but the pattern command doesn't even see the panel so i can't choose it.

How to rectangular pattern an icopy component in inventor 2016?

Thanks

 

Autodesk question..PNG

0 Likes
Reply
270 Views
1 Reply
Reply (1)

Mark.Lancaster
Consultant
Consultant

Post this question over in the Inventor general discussion group http://forums.autodesk.com/t5/inventor-general-discussion/bd-p/78.  This forum is for programming and creating interfaces for Inventor.

Mark Lancaster


  &  Autodesk Services MarketPlace Provider


Autodesk Inventor Certified Professional & not an Autodesk Employee


Likes is much appreciated if the information I have shared is helpful to you and/or others


Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.

0 Likes