Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Ilogic shared costum parameters

Anonymous

Ilogic shared costum parameters

Anonymous
Not applicable

Is it possible to share your custom parameters from you main assembly with your sub-assembly's? 

The costum parameters are inportant for the design and all of the sub-assembly's have to change when the Value of the parameter is changed. 
If there is an other option to share parameters and use them in multiple parts/assembly's, that's also an option.


I am looking forward to hearing from you.

0 Likes
Reply
Accepted solutions (2)
553 Views
2 Replies
Replies (2)

johnsonshiue
Community Manager
Community Manager
Accepted solution

Hi Bianca,

 

I don't think you can link a top-level assembly parameter to a subassembly. This can introduce cyclic relationship. However, you can drive all parameters from any level at the top-level assembly. For example, you have a parameter called "Top_Length" at the top level. And, you want it to drive "Sub_Length" at the sub level. You can simply write an iLogic rule to capture "Sub_Length" and the equate it to "Top_Length."

Would it work for you?

Many thanks!

 



Johnson Shiue (johnson.shiue@autodesk.com)
Software Test Engineer
0 Likes

Anonymous
Not applicable
Accepted solution

Thank you!

 

It know works like shown in the picture. It takes a little bit of time to do this for all the parts but it works!sharing parameters.PNG

 

 

 

 

 

 

 

 

 

 

 

Kind regards,

Bianca