Hello,
We are doing a lot of machine design where we are using Robot as one of main part int the assembly, but its hard to control an robot whit 6 degrees of fredom. Is there any application who can make this easyer or any function in Inventor to solve this issue?
Oyvind
Welcome to the community... You need to post this question over in the Inventor General Discussion group: http://forums.autodesk.com/t5/inventor-general-discussion/bd-p/78 This forum is for customizing and writing interfaces/programs for Inventor. The general discussion will give you better resilts.
Mark Lancaster
& Autodesk Services MarketPlace Provider
Autodesk Inventor Certified Professional & not an Autodesk Employee
Likes is much appreciated if the information I have shared is helpful to you and/or others
Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
