Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

View Boundary Box adjusting

The_Angry_Elf
Advisor

View Boundary Box adjusting

The_Angry_Elf
Advisor
Advisor

Once again, I'm having to post what should be a simple find, but isn't.

 

How in the world does one adjust the view boundary box? I'm not talking about the fence around a detail view and changing it from round to rectangle, etc. I'm talking about the fence/box you see around basic, projected or section views.

 

I know there's a way, or at least my old man's memory thinks there is as I've run into this very thing a few years back.

Why is stuff like this so dang hard to find either on these boards or in the Inventor Help? These boards would be a whole lot less cluttered if Adesk improved their Help documentation, but I digress.

0 Likes
Reply
250 Views
3 Replies
Replies (3)

Gabriel_Watson
Mentor
Mentor

Use Crop then change the crop sketch?

Gabriel_Watson_0-1695399008378.png

 

P.S.: section views have their own sketch you can also edit this way.

Curtis_Waguespack
Consultant
Consultant

@The_Angry_Elf wrote:

 

I know there's a way, or at least my old man's memory thinks there is as I've run into this very thing a few years back.

 


I don't think there is a way to do this other than what @Gabriel_Watson has suggested... which might be the method you are remembering ( but I think my old memory would not have remembered that trick, had he not mentioned it 🤔

 

This is what came to mind for me... just in case this is what you were thinking of, but this is only for an assembly, and only for assemblies with reference parts

 

Curtis_Waguespack_0-1695407377932.png

 

Gabriel_Watson
Mentor
Mentor
You nailed it Curtis.... I had this on the back of my mind to post too, but started a part instead of assembly and never saw the option.
0 Likes