Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

Inventor Forum

Reply
Highlighted
Post 1 of 1

Using referenced geometry from a part in an assembly

60 Views, 0 Replies
04-30-2012 09:43 AM

I am new to using Inventor 2010(used solidworks previously), and I am trying to figure out how to dimension to or constrain assembly features to part features. Is this possible in Inventor? Inventor does not seem to allow it at least in the default configuration.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post