Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Tube & pipe always dirty after rebuild all

3 REPLIES 3
Reply
Message 1 of 4
awatt
372 Views, 3 Replies

Tube & pipe always dirty after rebuild all

Using inventor 2020 with Vault pro 2020 add-in.

I have an assembly with a single tube & pipe run, and it ALWAYS is flagged as dirty after a 'rebuild all'.

I've checked everything out of the vault, so I have read-write access. But the vault tab in the browser will always put an asterisk on the top 3 levels of t&p.

 

Any ideas what I should be looking for?

- The components themselves are up-to-date

- No ilogic routines or triggers are to blame.

 

 

Labels (2)
3 REPLIES 3
Message 2 of 4
johnsonshiue
in reply to: awatt

Hi! This sounds like a corruption to me. There could be a way to purge the corruption but I am not 100% sure without seeing the files. If possible, please share the files.

Many thanks!



Johnson Shiue (johnson.shiue@autodesk.com)
Software Test Engineer
Message 3 of 4
awatt
in reply to: johnsonshiue

Here it is.  Have fun.

Message 4 of 4
johnsonshiue
in reply to: awatt

Hi! Many thanks for sharing the files! I think this is sort of a limitation. You may be able to reproduce the same behavior with any adaptive components. When you do Rebuild All, the entire adaptive chain will need to be updated and dirtied to ensure they are in the right place.

Thanks again!



Johnson Shiue (johnson.shiue@autodesk.com)
Software Test Engineer

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Technology Administrators


Autodesk Design & Make Report