Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Structure

kartikoutlook90
Participant

Structure

kartikoutlook90
Participant
Participant

 

See the attached image below, Having a frame of dimensions 780mm x 600mm and 900mm above the ground, the frame has a metal countertop 40 mm (Wrongly Dimensioned in the image), There will be a fixture which will be placed at the center of the table and will result in a load on the countertop in a specified region , how can i simulate it, i can use the frame structure analysis but it will only allow me to load the structure members but not the countertop, how can i achieve this and if there is a functionality kindly help me out on this one

0 Likes
Reply
213 Views
2 Replies
Replies (2)

kacper.suchomski
Mentor
Mentor

Hi

The countertop must be simulated in a separate operation. For this, it must be properly prepared - for example, areas designated for supports and loads must be designated.

 


Kacper Suchomski

EESignature


YouTube - Inventor tutorials | WWW | LinkedIn | Instagram

Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.


johnsonshiue
Community Manager
Community Manager

Hi! Or you may use Inventor Stress Analysis to simulate the assembly.

Many thanks!



Johnson Shiue (johnson.shiue@autodesk.com)
Software Test Engineer
0 Likes