Rendering problems: section view

[Anonymous]

Hello,

I try to render an assembly in section view. A few areas are shown correct in the rendered picture. But some are invisible.

Does anyone know how i can fix that?

Thank you for help,

Chris

[Xun.Zhang]

Hello @Anonymous,

This is a known problem and addressed by ticket INVGEN-12465 inside.

How about leverage the section view rendering in presentation environment?

Hope it helps!

[Anonymous]

I see bolts, elements that are interfering by default. Visuals don't like interfering elements. Does it work if you replace with non-interfering parts ?

[Anonymous]

---

@Anonymous wrote:

I see bolts, elements that are interfering by default. Visuals don't like interfering elements. Does it work if you replace with non-interfering parts ?

---

---

No, that doesn't work. In some views you can see through the right inner bearing ring. In other views like here it is visible.

@2

[Anonymous]

---

@Xun.Zhang wrote:

Hello @Anonymous,

This is a known problem and addressed by ticket INVGEN-12465 inside.

How about leverage the section view rendering in presentation environment?

Hope it helps!

---

Thank you for your answer. What is an presentation eviroment? The different light enviroments which can be choosen?

[swalton]

The Inventor Presentation environment is another file where you can create animations and/or exploded views to help document your assemblies.

See: http://help.autodesk.com/view/INVNTOR/2019/ENU/?guid=GUID-F4F6F136-003C-4D1C-9EC1-81102BADC867

[swalton · Accepted solution]

You might have better luck if you create an assembly-cut feature to get your section view.  That should not have the gap in the surface that you are seeing with the section-view tool.

If you don't want a bunch of assembly cuts in your design assembly, create a "rendering" assembly.  The rendering assembly has your design assembly as its only component.  Define all your cuts, lighting, etc in the rendering assembly and keep your design assembly uncluttered.

[Anonymous]

Finally i got it.

Thank you a lot.

[timdown73]

Hello, I'm having the same problem with section views not capping solids in rendered views. Has this issue been fixed yet?

[johnsonshiue]

Hi Tim,

I could be wrong but I vaguely remember a similar issue got fixed in one of the updates. What Inventor release are you on? Have you applied all the applicable updates?

Many thanks!