"Failed to save factory member" iPart

[Dmnutt32]

This was originally not an ipart. I added holes to the front and back between two different members and suppressed and computed as need. There are no problems in the model and all sketches are defined. The file will not let me generate files so I can do drawings of the part. I went over the forums and have not found anything to help.

[Dmnutt32 · Accepted solution]

FIXED

[CCarreiras · Accepted solution]

Hi!

In newer versions inventor has a new workflow to replace "iParts" to "Model States".

If you want to keep the iPart, you can generate each member and place each one in the drawing.
First you have to generate each member:

... but... i advise you to start using Model states, which has similar capabilities, but you don't need different files, all the members are in only one file.

Later you can select each member you want to place in the drawing:

Check the files.