Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

Inventor Forum

Reply
Highlighted
Post 1 of 4

Pack and Go

183 Views, 3 Replies
05-18-2012 03:31 PM

I am trying to find the best way to pack and go an assembly from my networked computer onto a stand-alone machine(work from home), then once I'm done editing a part, re-pack and go back onto the network machine.  I want to eliminate/ minimize the number of duplicate files created, and only over-write the files that I changed.

 

Any ideas?

Thanks,

-S

Post 2 of 4

Re: Pack and Go

05-18-2012 06:18 PM in reply to: SuprSpidey

I don't think Pack & Go will sort the files out by editing date. But what's the big deal about overriding the files? Just do it. Don't forget to collect the drawing files along with the model ones. That is overlooked often enough.

Regards,

Igor.

Web: www.meqc.com.au
Post 3 of 4

Re: Pack and Go

05-19-2012 04:12 AM in reply to: SuprSpidey

Are you using Vault?  If so then just check out the files out to your local working folder then pack and go them to a thumb drive to take home then when you bring them back from home copy and over write the ones on your local drive  and check back in.

 

If you are not using vault I would pack and go the files from the network to a location on your local machine them copy those to the thumb drive, do what you need to at home them when you bring them back, copy and over write the ones on your local.  Then call them up in a session of Inventor and do a file save as back to the network.

Best Regards,
Scott McFadden
Inventor Professional 2015
(Colossians 3:23-25)

Post 4 of 4

Re: Pack and Go

05-19-2012 07:41 AM in reply to: Cadmanto

If you are not using Vault, try a folder sync utility. I use ViceVersa Pro...

Mechanix Design Solutions inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post