Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

offset command

rjkdk
Enthusiast

offset command

rjkdk
Enthusiast
Enthusiast

For a long time I used the offset command easily. I could pick a line for instance and move to the new positon , click again and there woukld be the offset line.   For some reason I cannot do this anymore; now I must click continue.

 

So what settin have I inadvertently upset?

I have searched a lot and can not find a solution.

0 Likes
Reply
361 Views
2 Replies
Replies (2)

JDMather
Consultant
Consultant

What does your right click options say when you are in the Offset command?

 

Do you have Loop Select Active?

Do you have Constrain Offset Active?


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


0 Likes

rjkdk
Enthusiast
Enthusiast
Hello Autodesk, The right click produces the following: Continue Done Loop effect Constrain offset Previous view Home view Never had to do anything but place the cursor at the desired point and left click, now I need to select "continue". Wonder what I changed. Thanks Rich Ah ha I just now experimented some more , waited a bit longer until another symbol appeared then placed the location and it responded. Must have been to impatient; is there an adjustment on the wait time?
0 Likes