New hole command - selection, multiple points.

[jorgen]

The new hole command seems to have some inconsistent behaviour.
See attached video. I have allways been able to select a imported sketch with window or crossing within the sketch and then entering the hole command. But now it looses the selection. I cant do it from the part feature either.

After some struggling I noticed that from the sketch it can handle a few holes.  Please note I have done this in other parts with a lot more holes with the previous hole command. I'm on 19.1

See video.

[Yijiang.Cai]

@jorgen, many thanks to post this issue to us! It is reproducible, and has sent to development team for investigation.

[jorgen]

Great thanks, just some additional info: as mentioned, this is not consistent. I just managed to make the selection and holes, so suddenlyt it worked, I do not know if I did anything different. But then again, for another part it fails again...

[Yijiang.Cai]

@jorgen, if possible, could you attach the part for investigation here?

If you love my feedback for this issue, you could kudos or accept it as solution. Thanks!

[jorgen]

Ok see attached