Inventor Origin Plane Too Large

[cmcewanE2U82]

Origin planes in an assembly are so large I cannot resize them or see the end of them. Turned auto re-size on and off to see if they would correct but they don't. when using zoom extents it snaps right back to the assembly so there isn't anything out there that would make the planes this large.

Any insight or ideas would be appreciated.

[AEtzkorn]

Is your component a significantly long distance away from the origin?

[cmcewanE2U82]

No it is constrained to the center of the origin planes. But it is hard to tell because the planes are so large I cannot see them properly when highlighting them. I can try re constraining possibly but I'm pretty certain the origin point is centered.

[Alexander_Chernikov]

Hello!

Can you attach an archive with a test example of this problem (the assembly itself and the parts)?

What version and update are you using?

[johnsonshiue]

Hi! You may want to right-click on the origin planes -> uncheck Auto-Resize and then check it again.

Many thanks!

[cmcewanE2U82]

This was the first thing I tried. It appears the assembly is centered and I am unsure as to why the origin extends so far. I have tried panning to the end of the plane without success.

[cmcewanE2U82]

Unfortunately I can't due to the content of the model.

Inventor 2024.3

[BDCollett]

Does it happen with new assembly files?

[cmcewanE2U82]

No, this is the only time this has been experienced. New assemblies origins appear correctly.