Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

inventor dimensioning

Anonymous

inventor dimensioning

Anonymous
Not applicable

hello everyone, i am new to inventor. i am having this weird little issue. when dimensioning the angle to 45 deg. the line seg. kicks out. any help is greatly appreciated.

Screenshot (10).png

0 Likes
Reply
332 Views
1 Reply
Reply (1)

karthur1
Mentor
Mentor

Not sure what you mean by "kicks out"... but if you want the line to stop on the edge on the right hand side of the part like the image below.... project the edge to your sketch and then trim the line to the projected edge.

 

 

If this line is to create a chamfer like the one on the left side of the part, dont trim it off using an extrusion.  More effecient to use the chamfer tool.

 

Kirk

 

2015-11-01_2148.png