Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

Inventor Forum

Reply
Highlighted
Post 1 of 3

Forms in 2011

154 Views, 2 Replies
07-08-2012 09:52 PM

HI All,

Do we have forms in Inventor 2011, where I can find it?

I made an ipart last night in 2012 and later added the custom values to a Form that was right there in ilogic tool pallette. But this morning after I made same part in 2011 (at office) i can't find forms anywhere, need help guys.

 

Thanks alot.

 

Regards,

Sajid

Re: Forms in 2011

07-10-2012 03:36 AM in reply to: floccipier

The forms were introduced in version 2012. In Inventor 2011 they are not available.



Daniela Koloszko

Post 3 of 3

Re: Forms in 2011

07-10-2012 10:44 PM in reply to: Daniela_Koloszko

Thanks for your reply.

Yeah I noticed by comparing that option was not there in 2011.

I have another issue as stated in post

 

http://forums.autodesk.com/t5/Autodesk-Inventor/BLOCKS-PLACED-IN-ASSEMLIES-PARTS-SHOWED-IN-IDW/m-p/3...

 

I would appreciate if you get some time to have look,

 

thanks again,

Regards,

Sajid Mahmood

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post