Extrusion not following sketch lines
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I am working on a personal project for which I traced a raster image manually using splines. I got the sketch to where I wanted it and then extruded it and meshed the splines the rest of the way using sketch doctor in the extrude menu. After this Inventor found the correct geometry and highlighted it in the preview then the extrude added extra material outside of the preview, notice the lines in the part which are shown as where it is supposed to extrude vs where it actually extruded. Any ideas for how I could fix this or if there is a better way to convert a raster to design the I am also open to suggestions, thank you.
kelly.young has embedded your image for clarity.