error 9xc0000142on startup after installing Inventor 2010 on win 10.

[Anonymous]

I have tried all the registry  solutions I could find on the net, including reinstalling , setting LoadiApplnit_DLLS to "0" ( which it was set  at to begin with) and still Inventor will not start. Autocad Mechancial is ok.

Any Help?

John O.

[mdavis22569]

because Inventor 2010 isn't supported on Win10 

Can you get it back to 7 or 8.1?

or upgrade Inventor 

[mcgyvr]

Inventor 2010 is NOT supported on Windows 10..

Roll back to Windows 7 and stay there until you upgrade Inventor..

[Anonymous · Accepted solution]

Thanks,

I'll go back to WIN 7

[Anonymous]

I'm going back to win 7



Thanks

[mcgyvr]

---

@Anonymous wrote:
Thanks,

I'll go back to WIN 7

---

Good..

And in the future make sure you check out system requirements for any software you use on that computer.

This will avoid this problem next time...