End Fill

[Anonymous]

When I selected the weld one by one end fill is coming. If I selected the weld all together end fill is not coming. End fill tool also not producing any result. How can I fix this?

[mdavis22569]

Works for me for how it's suppose too .. 

Why do you want to pick all of them all at once?

 What does your instructor say?  What does your assignment say to do?     

[Anonymous]

My 1st face was one face my 2nd faces were two faces. So that weld was incomplete one. Is it possible to fill it by using end tool? Assignment suggests to use END FILL tool but it is not fixing the error.

I am ahead of the assignment work.

[mdavis22569 · Accepted solution]

---

@Anonymous wrote:

My 1st face was one face my 2nd faces were two faces. So that weld was incomplete one. Is it possible to fill it by using end tool? Assignment suggests to use END FILL tool but it is not fixing the error.

I am ahead of the assignment 

Since your ahead ... Might be a good time to go back and repeat an assignment that gave you the most problems ... Get a better understanding of it and more fluid in the use of the software .. Just a suggestion.

as for the assignment now .. Don't pick 2 for the 2nd face ..it should work fine then

[CCarreiras · Accepted solution]

Hi!

You have to do that in two steps.

[Anonymous]

Thanks.

What is the purpose of END FILL tool?

[mdavis22569]

by Paul (and Curtis)

https://books.google.com/books?id=KB4FCAAAQBAJ&pg=PA523&lpg=PA523&dq=inventor+weld+end+fill&source=b...

Why does your assignment recommend it .... what's the full exercise?

[Anonymous]

Here is what assignment says.

 

[mdavis22569]

do you see how on the end fill ...the hatching of a weld is shown on it ...

where  if you didn't it would look just grey ....