Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

Inventor Forum

Reply
Highlighted
Post 1 of 4

Content Center link problem

207 Views, 3 Replies
10-05-2012 12:52 PM

Hello everyone,

 

I am using content center for fasteners I want for my assembly.

However, when I close the assembly drawing and try to reopen it, the link has been lost between the assembly and the fasteners and I am unable to find them.

I have created a project file before I start the assignment thinking this will solve the linkage problem but no luck.

 

Any suggestions?

Post 2 of 4

Re: Content Center link problem

10-08-2012 07:23 AM in reply to: montyenright

Can you post your project file?

John Retzlaff
Post 3 of 4

Re: Content Center link problem

10-08-2012 06:22 PM in reply to: montyenright

Thank you for responding.

Can you explain post your project file?

 

Thanks, again.

Post 4 of 4

Re: Content Center link problem

10-09-2012 05:07 AM in reply to: montyenright

The path to your content center storage location should be in your project file, .ipj.

John Retzlaff
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post