Content center Family Table to part list

[jyothissurendran]

I have created a new colum in family table editor for a custom part in content center. After that i created an assembly using the same custom part from contentr center. Then i prepared the drawing for that i mean *.idw. In the drawing file i have to attach a part list. and i need to add the the new colum generated in family table to part list.Do we have any option available to  add the specified column in part list ?  

[Cadmanto]

I do not know of a way to link the family table column from the CC editor, but I know you can add columns to the BOM of your choice based on the list given.  You can do this through the styles editor under the manage tab here.

[jyothissurendran]

i know about this, but i am trying to get the colum which i added  newly on family table to the part list colum chooser 

[Cadmanto]

Unless you are talking about something else the only family table I know is inside of the CC editor.

Is that the one you are talking about?

Is it a property value header or is it a numerical value header.

[mpatchus · Accepted solution]

Try mapping the content center column to one of the Inventor iProperties or to a Custom iProperty.

[jyothissurendran]

I tried this option, but its not working. I have created a new column in  family table with name "Detail" and given  same name in map to inventor property with custom option. but its not working...

[jyothissurendran]

Hi mpatchu, Thanks for the Reply. ITs working now. Previously there was small mistake on my procedures... Thanks again.