center line issue

[Anonymous]

Help, obvious new guy here.

How do I get the small dash to  be centered in between the center of two flanges that share a hole?

Thanks.

[SBix26]

When picking the two edges, try picking the upper edge on the left side of the part and the lower edge on the right side.  My very brief attempt looked like it would work to center the centerline between the two segments of the the hole.

Sam B

Inventor Professional 2017 R2
Vault Basic 2017
Windows 7 Enterprise 64-bit, SP1
Inventor Certified Professional

[JDMather]

Use the point to point rather than bisector.

[Anonymous]

That is close, it looks like this when I do it:

[Anonymous]

Thanks for looking into this.

I cannot pick the center points I need because of other geometry:  The location of the centerline shown in the video is not correct, it should be centered about the hidden lines.

[Anonymous · Accepted solution]

RC on your view, Automated Centerlines

[Anonymous]

Outstanding, thank you!