Can't drag part after 1 constraint

[eucci]

I just migrated to INV 2023 (build 158)

In the assembly context, I am no longer able to drag a part around after placing the first constraint.

Typically, 3 constraints are required to lock down a part.

It will allow me to apply 2 more constrainst and it shifts, as it should, to the correct location.

But not being able to drag and move the part before fully constrained is a pain.

I did a re-built all, no effect.

There are no errors/warnings in the assembly.

This assembly was migrated from 2022

Any thoughts are appreciated.

[CCarreiras]

Hi!

The software must work as you expect and describe.

Something is wrong or need update.

• Check if you have all updates installed (2023.2)
• Check if you have the red cross active. If so, fix the errors.

[eucci]

As mentioned, there are no errors in the file.
All updates have been applied.

[BDCollett]

Can you share the files?

There are a few reasons this happens, but it is always because there is something causing conflict.

[eucci]

Unfortunately, I cannot share the file

[johnsonshiue · Accepted solution]

Hi! This is likely related to the presence of component pattern. It has been fixed on 2023.0.1 update. Please install 2023.0.1 update followed by 2023.2 update.

Many thanks!