Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

Inventor Forum

Reply
Highlighted
Accepted Solution

adding physical boundaries in assemblies

203 Views, 1 Replies
04-27-2012 10:00 AM

How do I set a constraint where 2 parts are attached to each other but do not phase through. For example if I have a door in a door frame, how do I add a constraint where the door can swing on it's hinges but get stopped by the door frame.

Either by using constraint limits or via contact solver... I'd use constraint limits..

Post 2 of 2

Re: adding physical boundaries in assemblies

04-27-2012 10:35 AM in reply to: vasily_gorbounov

Either by using constraint limits or via contact solver... I'd use constraint limits..

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

-------------------------------------------------------------------------------------
2017 Product Design Suite Ultimate
Windows 7 64 bit
Core i7 4820k processor (OC'd to 4.4Ghz), Nvidia GTX 770, 16G RAM


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post