3D Connexion Part Does Not Rotate Properly

[Anonymous]

I think this is a bug.

Every day on every part when I am navigating with the 3D controller the part starts to move in the opposite direction that I am commanding. The cube always follows the input from the mouse but the part does not. I may have to make a video to show it but if the cube is spinning clockwise sometimes the part spins counter clockwise, for a while before it corrects itself.

[JDMather]

Yes, please make the video.

Be sure to include image of your 3DConnexion Control Panel settings.

Before you make the video - you also do these three steps -

1. Make sure you have the latest 3DConnexion driver.

2. Unplug the device.  If it is a Navigator hold down the 2 buttons (if not a Navigator - check the 3D Connexion website for which buttons to hold).  Continue to hold the buttons for 15 seconds while plugging in the connector - this resets the firmware.

3. In the system tray right click on the 3D Connexion icon and select Calibrate (do not touch the device during calibration.

Now create your video demonstrating the behavior that you see and attach the video here.