22 Kudos

Spline should be in 3 D by bending it like a wire not in a plane

Status: Future Consideration
by Advocate devilal020795 a month ago |

T-Spline should be in 3 D by bending it like a wire not in a plane. After selecting a Spline it works in a single plane only. Can we expect a Spline in 3 D plane which will act as wire after selecting pipe command along a path.Capture.JPGdd.JPG

Status: Future Consideration

Thanks for the idea - this is an area where we are planning to improve, but not sure when we'll get to it yet. It is a future consideration. 

Comments
By: Advocate devilal020795
a month ago |

After selecting a Spline command from Tool Icon it works in a single plane only. This Spline can be pull or push by dragging a point in a selected plane of Sketch. Can we pull or push a Spline in 3 D by placing a User Coordinate System (UCS) in Fusion 360. 

By: Advisor
a month ago |
By: Community Manager
a month ago |
Status changed to: Future Consideration

Thanks for the idea - this is an area where we are planning to improve, but not sure when we'll get to it yet. It is a future consideration. 

Showing results for 
Search instead for 
Do you mean