More Control Over Display of Origin and Default Planes For All Workspaces

[julesmanson424]

Allowing finer control over the display of default construction geometry (origin and planes XY, XZ, and YZ) onto the canvas from inside the Browser. This would make it very helpful in giving the engineer a good point of reference when one is needed. When default construction geometry is set to on from the Model Workspace the following other Workspaces do not display default construction geometry on the canvas nor are display controls given in the browser: Animation, Simulation, CAM

[keqingsong]

Hey there! Thanks so much for submitting your idea. Unfortunately, this idea did not get a lot of votes from the community, and now is 2 years old. We're changing its status to archived. If you still feel strongly about this idea, you can resubmit it. Check out some idea submission best practices here: https://forums.autodesk.com/t5/community-faq/ideas/m-p/5384681#M44