Curvature comb for curves/sketches

[cekuhnen]

this would be ideal because I lay down curves faire them out using this approach in Rhino / Alias and then generate the surfaces based on those clean curves I first sculpted.

[deyop]

After creating a spline you will find an option on the marking menu for "Setup or Toggle Curvature Comb Display". 

Is this what you were thinking of?

[cekuhnen]

Yes this is what I was looking for.

However it is ilogical that:

1. the main Inspect main menu does not apply to sketches

2. that the curve needs to be selected for this option to show up - selecting a point on the curve does not show the menu

3. you have to be in edit mode to be able to get the curvature option listed

But again thank you for pointing out that it is there - just burried in the interface.

[cekuhnen]

you guys will not improve that UI issue?