Comentario
08-11-2024
01:11 PM
- editado
08-11-2024
01:15 PM
08-11-2024
01:11 PM
- editado
08-11-2024
01:15 PM
This option would make it a lot easier and efficient when modeling footings on walls with interior/exterior construction that is not of equal depth.
When modeling exterior insulation wall details, every time I change or touch the wall which the footing is hosted by, the footing itself defaults back to the center of wall. I gave up on adjusting them until the end of the project, just another added workflow step that is not necessary.