Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Advocate
Advocate

In terms of tagging, it correct to show it as height x width in section.

 

Where I agree is the confusion in design which I always consider width x height. The worst is when I have a vertical grille at say 400x150 and I attempt to create duct in section from said grille, it draws at 150x400 by default, even though it says 400widthx150height, causing unnecessary drawing work.

 

If anything, they should just add an option to disable this inversion in modelling, but keep it enabled by default for those used to this less than perfect workflow. Simple.