Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Advisor
Advisor

Why would you have a space between the tip of the leader for a spot elevation? Spot elevations are supposed to be precise to exactly where you are pointing. If your leader does not touch the point you are elevating you are just adding confusion. Sure this might be ok at close up scales when elevating the top of a wall, but then what happens on your site plan when marking spots for grade? The scale of those drawings is usually larger and thus the graphical space makes the tip that much further away.

 

If you are trying to use spot elevation elevation tags in section, that is what levels and dimensions are for. 

This seems like a request for a change to revit that is not best practices. 

 

Detail lines are most commonly used for detailing and they need to be cut, this is asking for a change that has one small very specific edge case but is a detriment to almost everything else.