Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Collaborator
Collaborator

I haven't had a problem with snaps, but I would like to bring up that when you are trying to dimension corners of objects if you need to dimensions something diagonally.

To even select the corner you have to cycle through using the tab key, only to see the highlighted corner point is infinitely small.

 

Can you see the highlighted corner selection in the screenshot, it is almost not visible.

Dimensioning to corner of a floor.jpg

 Why not make this corner selection more visible like a corner snap?