Comentario
08-02-2021
01:59 PM
- editado
08-02-2021
02:00 PM
08-02-2021
01:59 PM
- editado
08-02-2021
02:00 PM
I voted for this because it makes sense. Depending on how you model, a column may run through various levels so the painted finishes specification could vary along it's length. Similar for beams that cross different compartments.
Probably this needs to be a bit more high level than spitting faces i.e. for an automated manufacturing process you perhaps would like to extract from the BIM model curve parameters along a member where the applied finishes varied (stop/starts).