Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Contributor
Contributor
Same as you not trying to eliminate all pipe just stubs. I think with the
connector matching feature it will only modify the connection of the pipe
not the fitting. I had posted this as a suggestion a while back. Since in
most cases the pipe is stock or cut in the field its a lot easier to apply
a crimp in the shop then the field so we would want to change the end
treatment of the elbow or fitting in almost all cases.

You are also right sometimes there's a few options for matching. So it
would probably best if the mismatch dialogue came up and then even better
filtered to only the mating connectors available.