Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Anonymous
Makes sense. I guess I've never tried to eliminate "all" pipe...just a short so didn't think you could do that.

Seems as though this could use the "connector matching" that was added to help facilitate dropping a grooved coupling on a buttweld system. A connector essentially is configured to indicate it's "mating" connector. In this case, if the part you were stretching to would have it's connector match configured and that would be applied.
May still be some holes in cases where there's multiple possibilities to "match". The question then is...do you change the connector of what you're stretching or the one you're stretching to in a fitting to fitting case.
None the less, seems like it could help reduce the number of cases where you're having to manually touch it.