Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Autodesk
Autodesk

Hi Michal-- Thanks for your request, can you clarify a bit further?  If I create a Detail View (View > Create > Callout > Rectangle), and open the created view, it is already possible to draw duct and pipe place holder.  

 

If you are more generally looking for a mechanism to intelligently connect the model to a schematic (is that what you mean by a Smart Schematic?), then that is on our roadmap (see the Create section under MEP).