Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Collaborator
Collaborator

I create a schematic as a whole and see if it fits on a single sheet.

 

If it doesn't fit I will duplicate the schematic and remove from each the duplicated sections.

 

Sometimes I do this splitting up early on, sometimes I do it at the end. It depends on the project, I usually have a good idea before I start whether it will fit or not.

 

I would normally try to keep my schematics split up by floors so its not usually a huge problem.

 

I don't want a new method that is different, I want one that is better. What you have suggested will work perfectly well and I'm not knocking you for that.

 

There are accepted ways of doing things and I prefer to stick to them, it tends to remove the opportunity for errors.