Sorry for the delay but I am quite busy.
To answer your question: Not exactly.
Example:
I draw a path for a railing.
Clients specs demands each post on 900mm.
This is the result.
I set start and end post to none
Now I want the option to delete th first and the last non continuous rail.
Your option is ok if I draw a path with the correct length.
Let's try this:
Result is acceptable.
But the fixed length of 900mm is not a good way of working.
I change the justify parameter for the balusters from "center" to "spread to fit" (max 900mm).
Better!
But now the corners:
Yeah right !
Tried a lot but it isn't working with "spread pattern to fit"
Clients demand is that the posts should have a distance of 450mm from each corner.
Tried something else (see below).
This is looking good.
Except for the start and end post!
So I have to set these to none (or is there another solution I overlooked).
This looks ok but now the top rail is too long (which can be changed) and the non continuous rail as well (which can't be changed).
After some "tweaking" though I can get this result (I changed too much parameters).
I think I have to admit that extending the rail is the solution for my first problem (I think) but now I created another problem.
Is it possible to set the posts (balusters) at a fixed position from the corners (450mm in the X and 450mm in the Y direction) and divide from there at max. 900mm?