Anuncios
Welcome to the Revit Ideas Board! Before posting, please read the helpful tips here. Thank you for your Ideas!
Comentario
Advocate
Advocate

Automatic sketch tool in ceilings can be dangerous. Especially when wall thicknesses varies along one linear direction. For example, a 4 inch wall changes to become 12" inch wall along one edge of a room. Now in an event where these wall thickness are changed, any adjustment that happens to the wall layout may prompt you to delete ceiling. If someone is not paying attention then the ceiling along with all the hosted elements are deleted. The reason being, the change in wall layout/alignment affects the boundary sketches of the automatic ceiling prompting for removal of little sketch segments the tool creates during automatic ceiling command.

 

To prevent this from happening, these tools must not remember the edges formed around the walls because of different thicknesses. Currently, it remembers them and change in thicknesses may prompt for edge removal and thus the ceiling and any other ceiling hosted elements.

 

See attached Image.AutoCeiling.PNG