User Interface Defaults

[jonathan.calkins]

Is there a way to change defaults in Inventor like under CAM and the drilling cycle, I always have to select "deep drilling - full retract" and set the pecking depth to 0.100. Other settings like drill through depth and the like, would be nice to have it default to a value determined by the user.

Is there a way to set these default values, like a macro setting adjust? The program has defaults, obviously; it would be nice if there was a way to edit them.

I have searched around and I am not seeming to find exactly what I am looking for. If someone could point me in the right direction, that would be great.

[ckautz · Accepted solution]

Make a file specifically for CAM templates, and make your drilling cycle. Open "Compare and Edit..." and set to your desired value. Then "Store as Template" or "Save Parameters as Default"

[jonathan.calkins]

Thank you so much. That is exactly what I was looking for.