HSM Support Forum
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. To translate this discussion, select the language.

HSM Support Forum

Reply
Highlighted
Post 1 of 1

Analyzing model for drilling geometry crashes SW

23 Views, 0 Replies
04-20-2017 09:11 AM

I see a lot of people having trouble with the model analyze on generating a drilling toolpath, but even defaulting to not check geometry leads to the same results. Unfortunately I had to start on a non-native x_t file, which has approximately 13,000 surfaces and there are about 1,000 holes. Is there anyway to disable this deep analyze?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post