Community
HSM Post Processor Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Mitsubishi M70 milling post and G84 code

2 REPLIES 2
SOLVED
Reply
Message 1 of 3
hlavis.bk
1384 Views, 2 Replies

Mitsubishi M70 milling post and G84 code

Hello,

 

I use a built-in post for Mitsubishi M70 milling and the only thing that does not work properly is tapping cycle G84. The problem is that the post exports feedrate in mm/min while the machine wants mm/rev - can somebody help me to fix the postprocessor?

 

Postprocesor enclosed

 

Thanks in advance

 

T.H. 

2 REPLIES 2
Message 2 of 3
parobillard
in reply to: hlavis.bk

@hlavis.bk

 

Try this one!

 

NOT TESTED AT YOUR OWN RISK

Message 3 of 3
biester26
in reply to: hlavis.bk

You can also change parameter 1268 Bit 2 to 1.  That will change the tapping cycle to IPM.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report