Community
HSM Post Processor Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Fusion360 PP needs to change

1 REPLY 1
Reply
Message 1 of 2
kanokwan25310104
57 Views, 1 Reply

Fusion360 PP needs to change

Hello experts,

I need some one help me to change the code as following,

I need the PP likes this.

%
O1001
(T3 D=8. CR=0. - ZMIN=-20. - FLAT END MILL)
G90 G94 G17 G49 G40 G80
G21
G28 G91 Z0.

(2D CONTOUR1)
N1 T3 M06
S3000 M03
G54G90G00 X1. Y32.  (need to put WCS and G90 this line)
G43 Z50. H03

G04 X4.0 ( Need to put G04 X5.0 this line)
G00 Z6. M08  (Need to put M08 this line)
G01 Z2. F333.

cutting program

G00 Z10.0 M09 ( Need M09 before go to ZRN)

G91G28Z0

M05

M01

 

 

Please advise.

Thank you in advance.

1 REPLY 1
Message 2 of 2

Hello @kanokwan25310104 ,

 

I've tried to tune your post as you requested.
Please try following these steps:

1- Add coolant-off command to line 484:

 

andreaamilo_0-1734104492632.png

 

2- Remove G90 code from line 512. This is the new edited line:

 

andreaamilo_1-1734104570030.png

 

3- Add G04 code and move coolant command to lines 537 and 538, as shown below:

 

andreaamilo_2-1734104625576.png

 

4- Remove coolant-off command from line 1523:

 

andreaamilo_3-1734104774697.png

 

5- Add G90 command to the existing line 2757:

 

andreaamilo_4-1734104885381.png

 

 

You should get an output very similar (not exactly identical, but working in my opinion) to what you requested.

Please test it carefully and let me know.

 

 



Andrea Amilo

Senior Technical Consultant

Autodesk Knowledge Network | Fusion 360 Webinars | Autodesk Make

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report