[Fanuc Control] Doosan 3/5-axis VMC (FANUC)

[hawk_]

I would like to ask if someone have any idea how to add/activate supporting of 4-axis programming to that post (Wrap toolpath) to not get error like below?

###############################################################################
Error: This post configuration has not been customized for 5-axis simultaneous toolpath.
Error at line: 751
Error in operation: '2D Adaptive1'
Failed while processing onSection() for record 363.
###############################################################################

[Marek_Skotak]

It is necesary allow this in a post. 

[hawk_]

###############################################################################
Error: Error: Tool orientation is not supported for available machine axes.
Error at line: 1

Stack dump:
("Tool orientation is not supported for available machine axes.")@:0
onOpen()@C:\Users\Swiety\AppData\Roaming\Autodesk\Fusion 360 CAM\Posts\doosan vmc fanuc.cps:290
Failed while processing onOpen().
###############################################################################

Even if "has 5-axis" is on exporting gcode still fails. For test I used "Wrapped Pocked - Complete" form tutorial projects.

[Marek_Skotak]

send me your project. 

Would be better for solve problem

[hawk_]

You will find it in fusion:  CAM Samples -> Ultimate -> Wrapped pockets - complete

[Marek_Skotak]

Hi,

 postprocessor is set correctly. First question which i need know. Do you have a 5 axis machine or machine with 4 axis additional table?

On a 5 axis machine Table / Table you cannot do this. Because kinematics of this machine cannot do this. 

If you have 4 axis machine with a rotary axis around a X axis, i will recomended use another postprocessor like Fanuc A axis. 

 Postprocessor for VMC is for another kinematics, then example which you want proceed. 

[Marek_Skotak · Accepted solution]

https://cam.autodesk.com/posts/post.php?name=fanuc%20with%20a-axis

[hawk_]

I did not think that way, it should solve my problem. Thanks

[Marek_Skotak · Accepted solution]

Check this. If you set some non real values for limit A xis in VMC it will works. 

[Marek_Skotak · Accepted solution]

It is only example that problem is in a A axis limitation. 

Which type of doosan you have? Please write correct configuration. 

[hawk_]

I checked like you point of it (limits 9999), its work. Setup are 4 axis machine with a rotary axis around a X axis. Still not sure its safe enought need to check it. Control unit FANUC 0i

[Marek_Skotak · Accepted solution]

If you have a Doosan with A axis post FANUC - Inverse Time and A-axis will works. I have many experience with Doosan in my area. 

This post (sometimes with some modification) im using still. 

[hawk_]

Thanks for the feedback, i will check it.

[Marek_Skotak]

You are welcome.