Enable Fanuc G43.5 vector output for older control unit

Enable Fanuc G43.5 vector output for older control unit

mario.kaiserXZ5XS
Contributor Contributor
168 Views
1 Reply
Message 1 of 2

Enable Fanuc G43.5 vector output for older control unit

mario.kaiserXZ5XS
Contributor
Contributor

Hello to all,

 

we are having a Fanuc 31is contorl unit with a 5-axis simultan machine. As we ware using the generic fanuc postprocessor we will get out for turning the table during machinging G68.2. Our control unit is not supporting this but the code G43.5. How can we activate this as in the postprocessor there is a section for it. Can we also change the outputs from IJK to ABC and that we are having only BC

 

Thanks for your help

 

MMario

0 Likes
169 Views
1 Reply
Reply (1)
Message 2 of 2

AdamKunzo
Collaborator
Collaborator

Hi Mario,

 

You will need to specify your machine in the defineMachine section.

 

If you need a help with this, send me a message. I offer post processor modifications as a service and I'll be glad to help.

0 Likes